adhesion agent

According to the servicing conditions and the capacity of the pneumatic forging hammer, oil-resisting butadiene nitrile rubber has been chosen as an element of its elastic shock-absorber, and polyurethane adhesive adopted as the adhesion agent for the absorber after a series of performance experiments.

本文根据锻锤的使用条件及设备能力，合理地选用丁腈耐油橡胶做为空气锤的弹性隔震元件，通过对多种胶粘剂进行一系列的粘接性能试验后，确定聚氨脂胶粘剂作为橡胶隔振器的粘接剂。

Silane coupling agent is which can enhance the interface adhesion between inorganic fillers and resins.

硅烷偶联剂是应用最广的一类偶联剂.

The coupling mechanism of silane coupler and its use as endcapper, adhesion promoter and dehydrating agent in polyurethane sealant are discussed.

论述了硅烷偶联剂的偶联机理及其作为封端剂、粘接促进剂和干燥剂在聚氨酯密封胶中的应用。

Adhesion agent HPAM and XC complex characteristic;

稳泡增粘剂HPAM和XC的络合性；

A modified asphalt adhesion agent was made using petroleum asphalt as base materialbutyl rubber as modifierrosin resin as tackifier and mica powder as filler.

以石油沥青为基料，采用丁基橡胶为改性剂，改性松香树脂为增粘剂，云母粉为填料，制成一种改性沥青胶粘剂。

The adhesion between wetting agent molecule and polymer material surface is accomplished by the hydration film in the form of intermediate phase.

指出润湿剂分子与高分子材料表面间的吸附是通过水化膜作为中间相来完成的。

Study of a New Carpet Adhesion Agent

新型地毯粘合剂

The melt adhesive used as the adhesion agent is solid gum and comparatively environment-friendly.

作为粘结剂的热熔胶为固体胶，比较环保。

Six type roughness of interfacial treating, type of young concrete and adhesion agent are studied on the interface of new and old concrete.

研究了6种粗糙率沟槽处理方式，新混凝土等级，界面剂对新老混凝土粘结面抗剪性能的影响。

Effects of resins, curing agent, film former, adhesion promoter, solvent carrier on primer were discussed.

讨论了树脂 、 固化剂 、 成膜剂 、 粘附促进剂 、 溶剂载体对胶接性能的影响.

In the molding process of low temperature coating honeycomb catalyst, the influence of the catalyst particle size distribution, the slurry solid content, pH value, viscosity, adhesion agent, surface active agent on the performance of the catalyst slurry was investigated.

在低温涂层式蜂窝催化剂的制备过程中，研究了催化剂颗粒粒度分布、浆料固含量、pH值、粘度、粘结剂、表面活性剂对浆料性能的影响。

Results The 5% HPMC, which is used as adhesion agent, can improve the dissolution of tablets and the surface of tablets is obviously superior to that added by Tween 80. Conclusion HPMC can improve the dissolution of tablets and the effect is obvious.

结果用5%HPMC作粘合剂不仅可改善片剂溶出度，而且片面明显优于加有吐温&80者。结论羟丙基甲基纤维素可改善片剂溶出度，效果明显。

The effects of resin, 3D stereo apparition agent, adhesion accelerator and anti-sediment agent on coating performance were discussed.

讨论了树脂、3D立体魔幻剂、附着力促进剂、防沉剂等对涂料性能的影响。

Based on the integration of author s practical experience in many years and his accumulated information, the paper introduced the technique methods of coating single composition protection adhesion on surface of the strain gauge and of filling two composition adhesion agent in the strain hole.

本文综合作者多年的实践经验与资料积累，详细介绍了应变片表面涂覆单组分保护面胶和应变孔灌封双组分胶粘剂的工艺方法。

The influence of each component on bonding of the adhesion agent has been introduced. The adhesion agent is suitable for cold construction of modified asphalt waterproof coil.

介绍各组分用量对胶粘剂粘接性能的影响，该胶粘剂适用于改性沥青防水卷材的冷施工。

When the adhesion sand density reaches to critical adhesion sand density, the adhesion sand casing concretion strength is related to the performance of the adhesion agent;

当黏砂密度达到临界黏砂密度时，黏砂套管的固结强度与黏胶剂的性能有关；

Pyrolysis GC-MS Analysis of the Adhesion Agent

一种胶粘剂的裂解GC-MS分析

( Influences) of 12 kinds of adhesives on strength and burning properties of the formed charcoal were investigated. Suitable adhesion agent was selected, and technology and formula were optimized.

通过考察12种胶粘剂对炭块的强度和燃烧性质的影响，优选出适用的粘结剂，并对生产工艺与配方进行了优化。

Applications of adhesion promoting agent PM-18 in the rubber compound for conveyor belt

黏合增进剂PM-18在输送带胶料中的应用

Inadequate bonding strength of adhesion agent was traditionally considered to cause project quality problems, but the traditional bonding mode is only on the basis of experience.

在外墙外保温的工程质量问题中，传统认为是黏结强度不够的原因，而传统的黏结方式也只是根据经验而定的。